Holes must then be placed onto the bottom base sheet metal (10x21 cm) sheet metal, these holes need to be placed nicely and equally apart so that it holds the servo in place, and so that its near the back part of the base.įor mine I placed the two L shapes at 3.5cm and 8.5 cm from the back of the base, they were also about a Cm in from the side so that the servo could fit snugly while still over hanging the edge nicely. On the top part of the L shape pieces of aluminum >L that part, must also have two holes drilled into them, they should be spread out apart enough so that the servo holes will be able to fit. Firstly with the base laid on the ground, we need the four small 4x1 cm pieces, with them they must be bent at about 1 cm in, from one side of the aluminum piece, this makes an L shaped piece, the bottom part of the L shape must then have holes drilled into themĪnywhere near the middle should be fine (of the L piece).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |